Dig Deep MK3 Erase Settings

Reset Dig Deep MK3 to Factory Defaults (from Editor version 1.21)

1. Open Firmware Upgrade → Erase Settings. Click YES, wait for the red LED to flash, then click NO when prompted for the memory check.
2. Click Upload Selected and wait a few seconds until all orange LEDs turn ON and the red LED flashes a few times.
3. Go to Settings menu and click Set Assignable Parameters to Default
4. Click Save Parameters.
5. Configure your desired Assignments, then click Assign (wait for the red LED to finish flashing).

If the pedal is frozen or “Erase Settings” shows an error

You can try starting the pedal without loading any stored settings:

1. Power the pedal only via USB (disconnect the 9V jack — it will not work otherwise).
2. Disconnect the USB cable, then reconnect it while holding the WAVE button until the blue LED below starts flashing.
3. In the editor, go to Connection → Scan and Link.
4. If the editor asks to upgrade the audio algorithm, select NO.
5. Repeat the Erase Settings procedure described above.